Re: What are Screwed Fittings used for in stainless steel?
...o weld so with smaller piping sizes (2" and smaller) the use of socketweld connections are good because they take less skill on the part of the welder to make acceptable welds. With socketwelded...
View ArticleWhat is the difference between boss connection and earth lug?
some area are mentioned on drawing for the earth connection in metallic structure Boss connection. but some electrical panel are showing earthing lug, is there any difference in the function of these...
View ArticleRe: Do I need any kind of plumber putty for installing a bathroom sink drain...
...t sink drain assemblies that I have seen come with a rubber gasket for the connection to the sink, and will always work better. If you cannot find one then putty will work fine, make sure it covers...
View ArticleGas Dryer connection.?
I just got a gas dryer, which I have never had before. I got it used. The gas line has a fitting on the end of it. The piping coming out of the dryer is threaded at the end. But I can not get the gas...
View ArticleRe: What is the difference between boss connection and earth lug?
...ire to a metallic case or ground. Botho of these are parts of a gorunding connection and are being used to describe where you should attach a ground connection . A detailed description of grounding...
View ArticleThe cable connection on back of tv broke. Fixable?
Is there a way to replace the threaded cable connection on my tv? It ripped out while I was moving. Or is it possible to hook my Comcast digital cable box to the tv via an adapter of some sort?
View ArticleRe: At minimum, how many threads need to be turned into a threaded water pipe...
Pipe threads are tapered so they need to be made up so the two pieces fit tight against the taper. This means they should be tighten to refusal using the correct pipe wrench size. For that information...
View ArticleSocket server question?
Suppose I have a threaded socket server. How do I send a message to a specific client? Each client would have a threaded connection to the socket server, so how do I send a message to a particular one(s)?
View ArticleAt minimum, how many threads need to be turned into a threaded water pipe...
At minimum, how many threads need to be turned into a threaded water pipe joint for adequate connection/joint?
View ArticleIs it possible to connect a push connecting hose to a threaded male connection?
normally push connecting hoses donot connect to a threaded male connection. I guess they have a smooth end that sort of locks into each other(not sure never seen one). i have a 3/4" threaded connection...
View Article